Machine maintenance and maintenance, involving a variety of management: it is only pointed out here that it is necessary to maintain the normal operation of the machine

The basic requirements met, other aspects of management, it is still up to the user to formulate the relevant rules and regulations to

To regulate.

1, air compressor: the moisture with water in the air duct is easy to reduce the life of the air compressor assembly, although there are three points at the entrance of the machine

Combined filtration, but if the place where the air compressor is placed has a humid climate, a large amount of water vapor will run through the operation of the air compressor

In this case, a freeze dryer shall be installed to thoroughly remove moisture from the air or discharge filtration from time to time.

Water content in water cup and water vapor in air compressor gas storage cylinder.

2, 3 points combination: the air pressure should be kept at 4: 6 bar. although the filter cup has the function of automatic drainage, if the filter cup

When too much water is stored, the water vapor in the cup can be removed manually.

3, lubrication:

(1) Class A oils and oils: for air pressure conditioning group, Esso (ESSO ESSTIC 32 #)\ medium oil (R68 #) pressure adjustment

Arrange the circulating oil of the group.

(2) Class B grease: all kinds of butter for bearing, linear guideway lubrication. Note: the machine is equipped with butter mouths.

Butter should be supplemented every 6 months to ensure lubrication.

(3)Class C grease:special lubricating oil for gear reducer. Intermediate oil extreme pressure 68#oil/ALAR 680#machine.

Oil / Esso (ESSO) 608 # oil / BP680# oil / Mobil (MOBIL) 636 # oil.

4. Other maintenance

(1) the machine should be checked before starting each time, and if abnormal is found, it should be overhauled and eliminated in a timely manner. In the event of poor lubrication,

The lubricant should be checked and added to all relevant transmission parts immediately.

(2) at the end of the operation, turn off the power supply gas source in time, clean the surface of the machine and discharge the air filter regularly

Condensate. Speed regulating valve, hexagram and all parts of the axis to avoid collision as far as possible.

(3) the linear guide rail must often wipe clean oiling and filling butter to prevent rust from affecting the accuracy.

(4) solvent, ink and other volatile products, do not place on the machine when using, do not use too many solvents to wipe the collective

Paint, control panel to prevent corrosion or damage to switches and wires resulting in functional damage.

5. Regular maintenance

Monthly maintenance: when the machine runs to the end of the month, all parts should be checked. If the lubricant solidifies, it should be erased and erased.

Wash with gasoline and reinject lubricant.

Semi-annual maintenance: under normal circumstances, the machine is thoroughly maintained every six months: comprehensive inspection of the active joint parts

No rust and abrasion, poor lubrication, if abnormal, immediately handle.

Annual maintenance: the machine runs up to one year and the machine should be fully inspected: the mechanical part of the machine needs to be checked for rust

Wear and lubrication, colleagues should check all trachea throat, if damaged, should be replaced immediately.